How To Apply Spray Foam Insulation to Rim Joists
Rim joists and sill plates are among the primary sources of cold drafts and energy loss in any home or building. Watch our professional installation team demonstrate how Tiger Foam™ seals these tricky joints, blocking air infiltration and creating an airtight thermal barrier.
Step-by-Step Rim Joist Application Guide
Follow these key steps to effectively seal rim joist cavities and subfloor perimeters:
1. Site Preparation & Cavity Clearing
- Remove Old Insulation: Clear out existing fiberglass batts, rockwool, or debris from the rim joist bays so the spray foam can bond directly to the wood substrate.
- Clean the Cavity: Wipe or vacuum dust, cobwebs, and loose material from the rim board, top plate, and subfloor underside.
- Inspect Penetrations: Identify outdoor hose bibs, electrical wiring, gas lines, or vent pipes passing through the rim joist for targeted sealing.
2. Spraying Technique & Nozzle Selection
- Use the Cone Tip Nozzle: The cone tip nozzle delivers a concentrated stream ideal for reaching deep into tight rim joist corners and angled cavities.
- Seal All Cracks & Gaps First: Direct a small bead of foam into the seam where the wood rim joist meets the mudsill, foundation, and underside of the subfloor.
- Build Thickness in Passes: Apply approximately 2 to 3 inches of spray foam to match the insulation depth of the adjacent exterior walls for complete thermal continuity.
3. Gun Angle & Distance
- Maintain Proper Distance: Keep the nozzle tip 12 to 18 inches away from the rim joist surface to ensure proper fan pattern and even expansion.
- Prevent Tip Clogging: Swivel the gun fluidly between bays. If you pause spraying for more than 30 seconds, replace the nozzle tip immediately to prevent cured foam from clogging the gun.
Safety & Compliance
Always wear full personal protective equipment (PPE)—including a NIOSH-approved respirator, full-body suit, safety goggles, and chemical-resistant gloves—when applying spray foam insulation.
Download Safety Data Sheets (SDS) |
View Health & Safety Guide
Always use proper safety gear when applying our products. To learn more about proper safety procedures please see our Safety Guide and always read the official SDS documentation for every product before use.


Spray Foam Kits