How To Apply Spray Foam Insulation to an Open Wall
Insulating open wall stud bays is the most common application for Tiger Foam™ kits. Watch our professional installation team demonstrate proper site prep, fan tip spraying techniques, layering, and trimming for a complete air seal.
Step-by-Step Open Wall Application Guide
Follow these key steps to ensure proper adhesion, smooth coverage, and an effective thermal barrier across open stud cavities:
1. Site Preparation & Masking
- Protect Surrounding Areas: Move or cover furniture, flooring, and windows with plastic sheeting or drop cloths.
- Mask Fixtures & Boxes: Cover electrical boxes, switches, outlets, and plumbing penetrations with painter’s tape to prevent overspray.
- Clean the Cavity: Ensure wall studs and sheathing are clean, dry, and free of dust or loose debris for maximum foam adhesion.
2. Spraying Technique & Layering
- Use the Fan Tip Nozzle: Attach the fan tip spray nozzle to achieve a wide, controlled spray pattern across the stud bay width.
- Apply the First Tack Coat: Start by spraying a thin, light first layer (approx. 1/2 inch) directly onto the rear substrate. This initial pass warms the surface and creates a strong bond.
- Build Depth in Passes: Allow the first layer to react and expand, then build up additional layers in passes to reach your desired R-value thickness.
- Maintain Nozzle Distance: Keep the gun approximately 12 to 18 inches away from the wall surface, moving in a steady, smooth sweeping motion.
3. Nozzle Care & Trimming Cured Foam
- Swap Tips During Pauses: If you stop spraying for more than 30 seconds, replace the nozzle tip immediately to prevent cured foam from clogging the gun.
- Trim Excess Foam: Once the foam has fully expanded and cured, use a spray foam hand saw or long utility blade to flush-cut any foam extending past the face of the wall studs.
Safety & Compliance
Always wear full personal protective equipment (PPE)—including a NIOSH-approved respirator, full-body suit, safety goggles, and chemical-resistant gloves—when spraying in enclosed areas.
Download Safety Data Sheets (SDS) |
View Health & Safety Guide
Always use proper safety gear when applying our products. To learn more about proper safety procedures please see our Safety Guide and always read the official SDS documentation for every product before use.


Spray Foam Kits
Accessories