How to Prepare Spray Foam Kits for Use: Setup Video Guide

How To Prepare Your Tiger Foam™ Kit for Use

Proper preparation is the single most important factor in achieving high yield, correct expansion, and a permanent thermal seal. Watch our step-by-step video guide below or follow our quick-start checklist before your first spray.

Pre-Spray Setup Checklist

Before opening your valves, walk through these essential preparation steps:

1. Inspect Your Kit

Check for Shipping Damage: Inspect the box and tanks upon arrival to ensure valves and hoses are intact.
Match Your Tanks: Verify that you have one A-Component tank and one B-Component tank in your kit.

2. Temperature Management (Critical Step)

Target Tank Temperature: 75°F to 85°F (24°C–29°C)
Why it matters: Spray foam chemicals react based on temperature. If tanks are too cold, the foam will be dense, under-expand, and result in lost coverage. If too hot, the foam can expand too rapidly or clog tips.
How to warm cold tanks: Place tanks in a heated room or use heating blankets prior to application. Do not expose tanks to direct open flames or extreme heat sources.

3. Connect Hoses & Gun Assembly

Align the color-coded hoses to their corresponding A and B tank valves.
Hand-tighten fittings first, then securely tighten with a wrench to ensure a leak-proof seal.
Keep the gun safety lock ON until you are completely ready to test-spray.

4. Put On Required Safety Gear (PPE)

Always wear proper protective equipment before opening chemical valves:

Respirator: NIOSH-approved respirator suited for spray foam application.
Eye & Face Protection: Chemical splash goggles or full-face shield.
Body & Skin Protection: Full protective suit or Tyvek coverall with long sleeves, plus chemical-resistant gloves.

Ready to Spray?

Once your tanks are at the correct temperature (75°F–85°F) and your PPE is securely fitted, fully open both tank valves and perform a short test spray into a cardboard box or trash container to ensure an even mix.

Download Safety Data Sheets (SDS) |
View Health & Safety Guide

Always use proper safety gear when applying our products. To learn more about proper safety procedures please see our Safety Guide and always read the official SDS documentation for every product before use.