Window & Door Pro

Window & Door Pro Insulating Foam Sealant

Applies to product ID# TFFB24 and TFFB12 single component foam sealants by Commercial Thermal Solutions, Inc.

Product Overview

Tiger Foam” Window and Door is an innovative, high yield one-component polyurethane foam specially formulated for professional results when filling, insulating and sealing around windows and doors. This product has been specifically engineered as a low pressure, low expansion formula to eliminate warping or bowing of door and window frames. This product creates a durable seal that stops air infiltration, provides high insulation value and saves both time and energy. It has excellent adhesion to most building surfaces, contains no CFC’s, HFC’s or HCFC’s and best of all is easy to use.

Key features:

  • Low expansion formula won’t damage framing
  • Expands to completely fill of cracks and voids up to 3”
  • Forms a permanent, airtight and water-resistant
    seal on nearly any surface
  • For both interior & exterior use.
  • Ready-to-use, disposable and recyclable.
  • Requires Professional Dispensing Gun (Sold Separately)

Operating Instructions

Preparation

1. Product is FLAMMABLE DURING DISPENSING.
2. Always wear protective clothes, gloves, and eye protection. Use only in well ventilated area or wear approved respiratory equipment. Contact and application areas should be dry, clean, free of dust, oil, grease or any foreign objects, debris and contaminants that could interfere with proper adhesion. Clean and degrease surface with dedicated Cleaner, acetone, isopropanol, ethanol (metals, glass) or detergent (plastics), and let it dry completely. Surfaces must be sound and in good condition. It is recommended to lightly spray surfaces with water prior to applying foam to enhance expansion and curing properties.
3. For best results and maximum yield, apply at temperatures 50oF to 86oF/ 10oC – 30oC. Use below 32oF /0oC is not recommended.
4. Shake the can vigorously for 30-45 seconds before attaching to the gun and also in-between uses.
5. Remove protective cap, invert can, and screw the can firmly onto the gun – do not over tighten.

Application

1. Maintain the can in upside-down, inverted position during the application.
2. Point gun in safe direction and slowly pull trigger to test dispense foam. Adjust control knob on gun handle to achieve the desired application flow.
3. Fill cavities to approximately 50% full to allow for foam expansion after application. Cracks wider than 2” should be filled gradually in layers.
4. Trim excess foam with sharp knife or serrated edge. Cured foam may be sanded, painted, or stained (not before 24 hrs. after application). Cured foam discolors and loses its stability and properties when exposed to UV light. Paint or coat exposed foam for best results.
5. If idle for 10 or more minutes between uses, shake can vigorously 30-45 seconds before reusing.
6. When not in use, gun valve should be cleaned with CLEANER.

Cleaning

1. Clean Foam Gun thoroughly with CLEANER immediately after use to prevent foam from hardening in gun.
2. Uncured Foam – Clean immediately with CLEANER or acetone.
3. Cured Foam – if hardened on skin – use an industrial cleaner with pumice. Repeat process until foam is removed. Cured foam must be mechanically removed or allowed to wear off in time.

Join our mailing list to receive
special discounts and promotions!

Name  
Email   
Subscribe Unsubscribe

Toll Free: 1-800-664-0063
International: +1 732-927-2090

Fax Number: 1-877-415-1185
International Fax: +1 732-927-2091

PayPal Acceptance Mark