Gap and Crack Filler Pro

Gap and Crack Pro Insulating Foam Sealant

Applies to product ID# TFGC24 single component foam sealant by Commercial Thermal Solutions, Inc.

Product Overview

Our most economical formula, Tiger Foam™ Gap and Crack Filler is an innovative, one-component general purpose foam designed for filling, insulating, and sealing gaps, cracks, and openings in the interior and exterior of buildings. This ground-breaking formula creates a durable airtight seal, and stops both outside air infiltration and energy loss. Tiger Foam™ Gap and Crack Filler provides a high insulating value, is economical, and saves energy year round. It has excellent adhesion to most common building materials including wood, glass, metal, masonry, and plastic. It’s the go to foam of choice for pros and D.I.Y’ers alike.

Key features:

  • Expands to completely fill of cracks and voids up to 3”
  • Forms a permanent, airtight and water-resistant
    seal on nearly any surface
  • For both interior & exterior use.
  • Ready-to-use, disposable and recyclable.
  • Requires Professional Dispensing Gun (Sold Separately)

Operating Instructions

Preparation

1. Product is FLAMMABLE DURING DISPENSING.
2. Always wear protective clothes, gloves, and eye protection. Use only in well ventilated area or wear approved respiratory equipment. Contact and application areas should be dry, clean, free of dust, oil, grease or any foreign objects, debris and contaminants that could interfere with proper adhesion. Clean and degrease surface with dedicated Cleaner, acetone, isopropanol, ethanol (metals, glass) or detergent (plastics), and let it dry completely. Surfaces must be sound and in good condition. It is recommended to lightly spray surfaces with water prior to applying foam to enhance expansion and curing properties.
3. For best results and maximum yield, apply at temperatures 50oF to 86oF/ 10oC – 30oC. Use below 32oF /0oC is not recommended.
4. Shake the can vigorously for 30-45 seconds before attaching to the gun and also in-between uses.
5. Remove protective cap, invert can, and screw the can firmly onto the gun – do not over tighten.

Application

1. Maintain the can in upside-down, inverted position during the application.
2. Point gun in safe direction and slowly pull trigger to test dispense foam. Adjust control knob on gun handle to achieve the desired application flow.
3. Fill cavities to approximately 50% full to allow for foam expansion after application. Cracks wider than 2” should be filled gradually in layers.
4. Trim excess foam with sharp knife or serrated edge. Cured foam may be sanded, painted, or stained (not before 24 hrs. after application). Cured foam discolors and loses its stability and properties when exposed to UV light. Paint or coat exposed foam for best results.
5. If idle for 10 or more minutes between uses, shake can vigorously 30-45 seconds before reusing.
6. When not in use, gun valve should be cleaned with CLEANER.

Cleaning

1. Clean Foam Gun thoroughly with CLEANER immediately after use to prevent foam from hardening in gun.
2. Uncured Foam – Clean immediately with CLEANER or acetone.
3. Cured Foam – if hardened on skin – use an industrial cleaner with pumice. Repeat process until foam is removed. Cured foam must be mechanically removed or allowed to wear off in time.

Join our mailing list to receive
special discounts and promotions!

Name  
Email   
Subscribe Unsubscribe

Toll Free: 1-800-664-0063
International: +1 732-927-2090

Fax Number: 1-877-415-1185
International Fax: +1 732-927-2091

PayPal Acceptance Mark